Cummins Isx Flywheel Housing Torque Specs May 2026

Clean all sealing surfaces and apply a 1.5 to 2.0 mm bead of Cummins-approved sealant (Part No. 3164070) to the housing's back side.

Use guide studs to support the housing during installation to avoid damaging the sealant bead.

Torque values vary slightly by the size of the mounting capscrews used: 49 N·m [36 ft-lb] M12 Capscrews: 85 N·m [63 ft-lb] Cummins Isx Flywheel Housing Torque Specs

To ensure the housing seals correctly and stays aligned, follow these standard steps:

Tighten all capscrews in a crisscross or star pattern , typically starting from the center and moving outward. Clean all sealing surfaces and apply a 1

If you are reusing a housing or installing a new one, checking for is mandatory. Misalignment can lead to premature wear on the clutch and transmission. Max Allowable Runout: Typically 0.13 mm [0.005 in] .

Allow the sealant to dry for at least 30 minutes before starting the engine. Alignment Check (Runout) Torque values vary slightly by the size of

If the alignment is out of spec, you may need to remove the locating dowel rings and realign the housing manually using a dial indicator. X15 Cummins Flywheel Bolt Torque Specs - Expert Q&A Guide

The housing must be installed within 10 minutes of applying sealant to prevent it from skinning over.