Press and hold the , [Main Menu] , and [OK] keys simultaneously.

: A version mismatch between the installed control card and the drive's power card. Step-by-Step Troubleshooting Guide

This error is almost always hardware-related rather than a programming mistake. The most common reasons include:

: Defective EEPROM data on either the power card or the control card.

If the error persists after a power cycle and manual initialization, it is highly likely that a is required.

Because Error 1027 is an internal fault, manual intervention is often limited. However, you can follow these steps to verify if the drive can be recovered: Disconnect the mains supply.

: Contact an authorized Danfoss Service Partner or supplier to verify if the drive's internal components have failed. Top ten VFD tech support calls - Danfoss

Danfoss is a critical internal communication fault that typically occurs within the VLT series frequency converters (such as the FC 102, FC 202, and FC 302). It indicates that the control card is unable to communicate with the power card or that an internal CAN telegram cannot be sent . What Causes Error 1027?

If you are qualified to open the drive, check the ribbon cables or connectors that link the control card to the power card. A loose connection can trigger communication errors.

Wait until the LCP (Local Control Panel) display turns off completely. Reconnect the power and see if the error clears. Disconnect mains power and wait for the display to go dark.