Dp Dual Trac 20 Assembly Instructions Full ((install)) -
Start at the lat bar attachment point. Thread the cable over the top pulleys, down through the "floating" pulley block, and back up to the anchor point on the frame.
Run the handles through a full range of motion without any weight plates pinned to ensure the cables are tracking correctly.
Tighten all bolts from Step 1 through Step 3. If the cables feel too loose, adjust the floating pulley bracket position or use the chain links usually provided at the cable ends to take up the slack. Safety & Maintenance dp dual trac 20 assembly instructions full
Lift the top horizontal frame piece onto the vertical upright. Secure it with the heavy-duty bolts and washers.
Use a silicone-based spray on the guide rods for smooth movement. Never use WD-40 , as it attracts dust and creates friction. Start at the lat bar attachment point
Lay out all bolts and nuts by size before starting. This prevents using the wrong hardware in early steps. Step 1: The Main Frame and Base Start by assembling the "skeleton" of the machine.
Before you begin, clear a 6' x 8' space for the machine and grab the following tools: Two adjustable wrenches (or a socket set) A Phillips head screwdriver A rubber mallet (optional, for seating end caps) Tighten all bolts from Step 1 through Step 3
If your model includes the leg extension attachment, bolt the pivot arm to the front of the seat frame now. Step 3: Top Frame and Pulley Brackets
Insert the weight guide rods into the base. Slide your weight plates on one by one.
