Connecting a standard PC or a modern PLC to a Gilbarco dispenser often requires an interface converter to bridge the gap between RS-232/USB/RS-485 and the 2-wire current loop.
Typically 5787 bps , though some configurations may use 4800 bps. Data Format: 8 Data bits, Even Parity , and 1 Stop bit.
To successfully integrate a third-party controller, the following physical and logical parameters are standard: Connecting a standard PC or a modern PLC
Understanding the Gilbarco Dispenser Two-Wire Protocol The is a proprietary communication standard used to interface Gilbarco fuel dispensers with Point-of-Sale (POS) systems and third-party pump controllers . It operates on a current loop principle, traditionally at 45 mA , although variants like 20 mA or 60 mA may be encountered depending on the specific hardware. Core Technical Specifications
Uses an 11-bit data format for maximum throughput. polling for status
Third-party developers must implement commands for bringing a pump online, configuring it, polling for status, and managing fuel sale data. Modern Upgrades
A multi-drop loop supporting up to 16 fueling positions on a single pair of wires. Communication Model To successfully integrate a third-party controller
The protocol follows a architecture. The pump controller (Master) initiates all communication by polling the dispensers (Slaves). Every unit on the loop receives the data, but only the specific unit addressed responds, while others ignore the message. Interface Requirements for Third-Party Systems
For newer installations, Gilbarco has introduced high-speed communication technologies like the Invenco Link