Hormann A445 Manual __exclusive__ May 2026

The 7-segment display provides immediate diagnostics for system faults. Sectional Door - Shakti Hormann

The is a high-performance industrial door control unit designed for 3-phase operators like the WA 400 or WA 400 M . Housed in a robust IP 65 rated enclosure , this unit is the standard for modern warehouse and commercial door management. Core Technical Specifications

Set the by stopping approximately 5 cm before the floor and fine-tuning until "L" with a lower dash appears. A445 Error Codes & Troubleshooting hormann a445 manual

Enter programming mode by long-pressing the button until "00" appears.

Only qualified electricians should perform the electrical setup to avoid life-threatening hazards. Set the by navigating to menu "01" and

Set the by navigating to menu "01" and holding the "Up" button until the desired position is reached, then press Enter.

The A445 acts as the "brain" of the sectional door, managing power distribution and safety signals. 400V AC / 3-phase / N / PE. hormann a445 manual

Use separate cable paths for control wires and power lines to prevent signal interference. Ensure the mains cable enters the housing from the bottom . Initial Programming:

Integrated SKS (Closing Edge Safety Device) and photocell connections. Operating Temp: -20°C to +60°C . Installation and Commissioning

The control housing must be installed so the door is visible during operation but protected from extreme temperatures.