Stanley Fatmax Stud Finder 400 Manual ~upd~ -

: Keep the device still until you hear a final beep or see the "READY" icon. Calibration typically takes 1–3 seconds. How to Find Studs Once calibrated, you can begin your scan.

: Press and hold the activation button on the side. The device will emit a series of tones or show a "CALIBRATING" message on the LCD. stanley fatmax stud finder 400 manual

: With the button still held down, slide the device horizontally across the wall. Moving too fast can lead to inaccurate readings. : Keep the device still until you hear

: Open the rear compartment and connect a fresh 9-volt alkaline battery . : Press and hold the activation button on the side

: The midpoint between your two marks is the safest place to drive a screw. How To Use a Stanley Stud Finder

to find the other edge of the stud and mark it.