An essential guide for the vehicle lift. This comprehensive manual covers installation, operation, safety, and maintenance. Read on to maximize your workshop efficiency and safety. Table of Contents Overview of the Stenhoj DS2 Technical Specifications Pre-Installation Requirements Step-by-Step Installation Operating Instructions Safety Protocols Routine Maintenance Troubleshooting Common Issues Overview of the Stenhoj DS2

Once fully lowered, swing the arms out to the sides. Exit: Drive the vehicle carefully out of the bay. Safety Protocols Never exceed the maximum rated weight capacity. Never override or bypass the safety limit switches. Always use proper vehicle manufacturer lifting points. Wear steel-toed boots and safety glasses in the bay.

Screw the rubber pads up to touch the chassis. Initial Lift: Raise the vehicle slightly off the ground.

Drive the vehicle centrally between the posts.

Fresh concrete must cure for 28 days before installation. 2. Space and Clearance

To help you get the exact information for your specific workshop setup, could you tell me: The or year of manufacture for your DS2?

Verify all electrical connections are tight and corrosion-free. Conduct a load test with a heavy vehicle. Troubleshooting Common Issues Lift Will Not Rise Is the main isolator switch turned on? Check Fuses: Look for blown fuses in the control box.

Swing the lift arms under the vehicle lifting points.