Constant beeping usually indicates the lift is not parked on a charging point.

Before unboxing, ensure your staircase is compatible with the Levant’s specifications.

This guide serves as a comprehensive overview of the installation process, mirroring the technical specifications found in the official installation manual. 1. Pre-Installation Checklist

Place the rail on the steps, ensuring a gap of approximately 5 inches (12 cm) between the rail and the wall. Step B: Secure the Mounting Brackets Attach the feet: Slide the mounting brackets onto the rail.

Gently press the edges of the footrest and the chassis. The lift should stop immediately if it hits an obstruction. 5. Maintenance and Troubleshooting

Ensure a minimum staircase width of 28–30 inches.

Screw the brackets into the stair treads. For wood stairs, use the provided wood screws; for concrete, use masonry anchors. Step C: Mounting the Drive Unit

Immediately bolt the mechanical end stops at both ends of the rail to prevent the lift from over-traveling. Step D: Install the Seat Place the seat assembly onto the drive unit’s post.

Use a spirit level to ensure the rail is consistent.

on the stairs to check the length. If the rail is too long, it can be cut from the bottom end using a circular saw with a metal-cutting blade.

Thyssenkrupp Levant Stair Lift Installation Manual Full //top\\ «99% Essential»

Constant beeping usually indicates the lift is not parked on a charging point.

Before unboxing, ensure your staircase is compatible with the Levant’s specifications.

This guide serves as a comprehensive overview of the installation process, mirroring the technical specifications found in the official installation manual. 1. Pre-Installation Checklist thyssenkrupp levant stair lift installation manual full

Place the rail on the steps, ensuring a gap of approximately 5 inches (12 cm) between the rail and the wall. Step B: Secure the Mounting Brackets Attach the feet: Slide the mounting brackets onto the rail.

Gently press the edges of the footrest and the chassis. The lift should stop immediately if it hits an obstruction. 5. Maintenance and Troubleshooting Constant beeping usually indicates the lift is not

Ensure a minimum staircase width of 28–30 inches.

Screw the brackets into the stair treads. For wood stairs, use the provided wood screws; for concrete, use masonry anchors. Step C: Mounting the Drive Unit Gently press the edges of the footrest and the chassis

Immediately bolt the mechanical end stops at both ends of the rail to prevent the lift from over-traveling. Step D: Install the Seat Place the seat assembly onto the drive unit’s post.

Use a spirit level to ensure the rail is consistent.

on the stairs to check the length. If the rail is too long, it can be cut from the bottom end using a circular saw with a metal-cutting blade.