For environments where the keypad face may become worn, a replacement TS1162-LABEL (membrane) is available to restore the unit's appearance and button legibility.
The Challenger system identifies each keypad by its unique RAS address, which must be set manually before the unit is powered up.
Pull the bottom of the body away from the base and lift it off the top tabs. ts1162 installation manual
12V DC power from the Challenger LAN or an external power supply.
If the device is more than 100 meters from the main panel, it is recommended to use an external 12V power supply while maintaining a common negative (–) reference with the LAN. 3. Configuration (Addressing & Termination) For environments where the keypad face may become
This guide outlines the physical installation, wiring, and addressing procedures for the TS1162.
Test the keypad by entering a valid user code to arm/disarm the assigned areas. 12V DC power from the Challenger LAN or
Once physically installed and addressed, the keypad must be enabled within the Challenger system programming: Access the (Default code: 4346 ). Navigate to the RAS Configuration menu. Enable the specific RAS address you assigned to the TS1162.
Use the base as a template to mark screw holes. Use appropriate fasteners for the mounting surface (e.g., wall plugs for masonry). 2. Wiring and Terminals